HVAC Repair in Branson, MO
Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Taney County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work, most of it in the cold
Your furnace and air conditioner in Taney County get little rest. Heat runs October through April, seven months, then the system switches over and cools the house June through September, another four. Winter nights here average 27°F, so the furnace cycles on and off for hours to hold the house steady, and each start wears on the igniter and the parts that get the burner lit.
Most homes here heat with electricity, and power does not always stay on. Missouri saw 19% of households lose power for at least 24 hours in 2024, and this area has logged 10 winter storms and 136 damaging wind events over the past ten years. A storm that cuts power on a 27°F night leaves a house with no heat until it comes back on. In summer, afternoons averaging 88°F push the air conditioner to run long stretches just to keep the house cool.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 27°F
- the average winter night it heats against
- 88°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
- Why is my heat not working?
- Most often it is the igniter, a tripped limit switch, or a thermostat set wrong or dead on batteries. Check the thermostat first, since a blank or unresponsive display points there right away. If the thermostat looks fine, check the breaker and the furnace's own switch, the one that looks like a light switch near the unit. Winter nights here drop to 27°F on average, so a furnace that will not fire is not something to leave for later.
- Why is my system running but not cooling the house?
- If air is moving but it is not cold, the filter is a common cause. A clogged filter starves the coil of airflow, and the coil can ice over, which makes the problem worse the longer it runs. Check the filter first and replace it if it is gray or packed with dust. If the filter is clean and the air still is not cold, the system may be low on refrigerant, and that is a leak a contractor needs to find and fix.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it is set to heat or cool as needed, the batteries are good, and the temperature setting is actually past what the room reads. Next check the breaker for the system and, for a furnace, the switch near the unit that looks like a light switch. Check the filter too, since a dirty one can cause both weak heat and weak cooling. If everything there looks right and the system still is not doing its job, that is when a contractor needs to look at it.