A snow-laden tree branch with dripping icicles hangs in the foreground during a winter storm, with a snow-covered residential house visible in the background.

HVAC Repair in Osage Beach, MO

Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Camden County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a single hanging light bulb.

Osage Beach runs its system almost year round

Heat is on October through April, then cooling takes over for the five months after that. There is not much of a break in between, so the furnace and the AC both put in real hours before anything gets a rest.

Winter nights here average 25°F, cold enough that the furnace cycles on and off many times through the night to hold the house steady. Summer afternoons average 87°F, which keeps the AC running long stretches to keep up. Camden County has also seen 57 damaging wind events and 7 winter storms over the past ten years, and most homes here heat with electricity. When the power goes out, and in Missouri last year that happened to about one household in five for a full day or more, the furnace has nothing to run on until it's back.

7 months
October through April, your system heats
5 months
May through September, it cools
25°F
the average winter night it heats against
87°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing a gray furnace connected to white ductwork and a flue pipe extending through the shingled roof, with simplified furniture in the interior rooms.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

Why is my heat not working?
Start with the thermostat and the power to the furnace before you assume the worst. Check that the thermostat is set to heat and a few degrees above room temperature, and check the breaker and any switch on the furnace itself. If those are fine, listen for what the furnace does when it tries to start. A furnace that clicks but never lights often has a dirty flame sensor or a failed igniter, and with lows averaging 25°F here from December through February, that's not something to leave for later.
Why is my system running but not cooling the house?
Check the air filter first. A filter clogged with dust chokes off airflow across the coil, and the coil can ice over, which makes the air coming out feel warm even though the system is running. If the filter is clean and the air still isn't cold, the outdoor unit may not be doing its job, and a refrigerant leak or a failed compressor needs a contractor to diagnose. With afternoons here running near 87°F all summer, a system that's low on refrigerant will fall further behind as the day goes on.
What can I check before calling for HVAC repair?
Check the thermostat settings, the batteries in it, and the breaker for the system before anything else. Then check the air filter, since a filter packed with dust can make a furnace or air conditioner act like it's failing when it just can't move air. If the system runs but the house still doesn't feel right, or if you hear a new sound or smell something odd, that's worth telling the contractor when they come, since it points to what's actually wrong.